Paxar Monarch 9860, Operating Instructions Manual

Page: 89 / 114

Using the Smart Relay System 5-5
C o n f i g u r i n g t h e P a r t n e r P r i n t e r
The partner printer must be configured to 115200 Baud, No parity,
8-bit word length, 1 stop bit, and XON/XOFF flow control.
1. Select Setup , Port Settings , Serial Comm from the partner
printer’s Main Menu. If password protection in enabled, press
Feed/Cut three times, then press Enter/Pause before you see the
Setup Menu options.
2.
Select Baud Rate and press or to scroll until you see
115200. Press
Enter/Pause .
3. Press or to select Word Length . Scroll until you see 8.
Press Enter/Pause .
4. Press or to select Stop Bits . Scroll until you see 1.
Press Enter/Pause .
5. Press or to select Parity . Scroll until you see None.
Press Enter/Pause .
6. Press or to select Flow Control . Scroll until you see XON-
XOFF. Press Enter/Pause .
U s i n g t h e S m a r t R e l a y T e l n e t C o m m a n d s
See the following list of commands to configure the printers.
SET PRN RELay PORt [None/S2]
Sets the Smart Relay Partner Identification (port) number to None (no
partner printer) or S2 (partner printer connected to serial port 2). The
default is None.