Press
ENTER
or
ESCAPE/CLEAR,
depending on your
printer and try to continue printing. If the error
continues to appear, change the supply.
752
Printer sensed a mark in the wrong place.
753
Printer sensed a mark that is too long.
754
Printer has a ribbon problem. Check the ribbon for a
jam or remove any slack by turning the take-up reel
clockwise. Load a new ribbon.
755
Printhead is open. Close the printhead before
continuing. If the error persists, call Technical Support.
756
The printer is out of supplies. Load supplies.
757
Load supplies. The calibrated supply length differs by
plus or minus .25 inches from the format. Press
ESCAPE
,
FEED/CUT
, or the
up arrow
(9403) to print
on the current supply or load new supply and press
ENTER/PAUSE
.
758
Check supply. Either the supply is not seen or the
on-demand sensor is broken. Check for a label jam.
Clear the supply path or reload supplies. This error
may occur if you remove a label too quickly in
on-demand mode. The printer does not recalibrate
after this error.
759
Knife is not moving. Call Technical Support.
760
Knife jam. Call Technical Support.
761
The stacker is full or jammed. Empty the stacker or
clear the jam before continuing. The printer does not
recalibrate after this error.
762
Low battery. Recharge the battery.
763
Waiting to dispense label. Press
ENTER
or
FEED/CUT
,
depending on your printer.
Diagnostics and Errors
8-21
Summary of Contents for Monarch 9825
