8
SmartNode 10200A Series Quick Start Guide
The IP address of the management port is
192.168.200.10/24
. If it is not possible
to connect to the management port via IP, use the serial cable to connect to the
SmartNode Control host for the first time.
2.
Default HOSTNAME is the Control host serial number, which can be found in the
“Important Notice” sheet included with your shipment.
3.
Refer to the "Important Notice" sheet for the username and password to log onto
the SmartMedia WebPortal. Navigate to: HTTP://HOSTNAME:12358, to configure
the SmartNode unit. (username/password: root/root)
7.1 Connecting the console serial port
1.
Connect a CAT5 RJ-45 (male-male) cable (supplied with unit) between the COM
port of your computer and the serial port (labeled CONSOLE) of the SN10200A.
2.
If your computer’s serial port features a DB9 connector, use the DB9 to RJ-45
adapter supplied with your SN10200A. If your computer's serial port features a
USB connector, you will need to provide a USB to DB9 adapter.
Figure 9.
Connecting the console serial port
7.2 Connecting the Ethernet management interface
1.
Connect the supplied CAT5 Ethernet cable to the management port labeled
MGMT0 on the rear of the SmartNode 10200A (see
2.
Log into the SmartNode using the specific credentials included on the “Important
Notice” sheet that shipped with your unit. The management port is configured
with a static Class C IP address by default
S
e
r
ial Te
r
mi
n
al (PC)
Note
A Patto
n
Model 16F-561 RJ45 to DB-9 adapte
r
i
s
i
n
cl
u
ded with each
S
ma
r
tNode 10200A device.
CON
S
OLE Po
r
t
