SmartNode 10200A Series Quick Start Guide
11
•
Smart Media System Software Configuration Guide
–
A.0 Compliance Information
A.1 Compliance
EMC:
•
FCC Part 15, Class A
•
EN55022, Class A
•
EN ETSI 300 386 V1.3.3
Low-Voltage Directive (Safety):
•
UL 60950-1/CSA C22.2 No. 60950-1
•
IEC/EN60950-1
A.2 Radio and TV Interference (FCC Part 15)
This device generates and uses radio frequency energy, and if not installed and used
properly—that is, in strict accordance with the manufacturer's instructions—may
cause interference to radio and television reception. This equipment has been tested
and found to comply with the limits for a Class A computing device in accordance with
the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide
reasonable protection from such interference in a commercial installation. However,
there is no guarantee that interference will not occur in a particular installation. If the
equipment causes interference to radio or television reception, which can be deter-
mined by disconnecting the cables, try to correct the interference by one or more of the
following measures: moving the computing equipment away from the receiver, re-ori-
enting the receiving antenna, and/or plugging the receiving equipment into a different
AC outlet (such that the computing equipment and receiver are on different branches).
A.3 CE Declaration of Conformity
Patton Electronics, Inc declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. The Declaration of
Conformity may be obtained from Patton Electronics, Inc at www.patton.com/certifica-
tions.
The safety advice in the documentation accompanying this device shall be obeyed. The
conformity to the above directive is indicated by CE mark on the device.
