Cable installation
23
Model 2604 T1/E1 DACS Getting Started Guide
2 • Hardware installation
2. If you are installing the DACS in a 19-inch rack, go to step 3. Otherwise, place the DACS at the desired
location, then go to “Cable installation” on page 23.
3. Install the rack mounting ears onto the DACS using the mounting hardware provided.
4. Place the DACS at the desired position in the rack.
5. Secure the DACS in position with the mounting screws.
Cable installation
This section describes installing the power, ground, and network interface cables.
Installing the power cables - AC Unit
This section describes installing the power cables into the IEC-320 connectors on the DACS.
Do not connect
the remaining end of the power cables to the power outlet at this time
. Do the following:
1. Install a power cable into an IEC-320 connector (see figure 5).
Figure 5. IEC-320 connector and grounding stud locations
The AC receptacle that the DACS will be plugged into must be
located within10 feet (3 meters) of the DACS and must be easily
accessible.
To avoid the risk of injury from electric shock, the power cords connected to
the IEC-320 connectors must be grounded power cords.
CAUTION
WARNING