Novell Specific
UCONNECT Can’t Communicate with Print Server
1) Check the correct Network Number and NIC Address have been
entered
2) Ensure PeNet
TM
Print Server is functioning correctly (check the
power LED and status page production)
Status Page Shows No Novell Server or Queue Details
1) If Server shows, but no Queue details, then no Print Queues have
been assigned (See PCONSOLE Section 3.4 or consult your Novell
Administrator)
2) See section on “PeNet
TM
Print Server Unable To Login” (below)
Print Server Is Unable To LOGIN To Novell Servers
1) Check that ‘Allow Unencrypted Passwords’ has been set to ON
2) Ensure that the units Name and Password are as allocated in
PCONSOLE
3) Check that there is a connection available for PeNet
TM
Print Server
(use Monitor on the Server Console)
4) If Selective Login is enabled, ensure correct File Server name(s)
have been entered
5) Check that Novell Mode is not disabled
21
5.0 TCP/IP OPERATION
This section tells how to use the Print Server with a TCP/IP
network. Functions described include locating the Print Server on the
network, configuration, initialization, testing, printing, and FLASH
EPROM upgrading.
5.1 Locating the Print Server on the TCP/IP Network
When used in the TCP/IP environment, the Print Server has one
assigned Internet Address and one printer port.
5.1.1 Assigning the Internet Address
If it is not possible to use the UCONNECT utility to configure the
units Internet Address, then the following method should be followed:
1. Create an entry in the ARP table using the Unix command :
arp -S [ether] IPaddress NICaddress where...
IPaddress is the required Internet Address
NICaddress is the units NIC address
2. Use PING to send this new IP address to the NIC address of the
Print Server:
PING xx.xx.xx.xx where xx.xx.xx.xx is the IP address above
(continued)
22
NOTE:
This method will only work if the units Internet Address is
currently set to 0.0.0.0 and PING
will only affect the unit with
the NIC address entered in the ARP table.
Some versions of Unix will require the ‘ether’ command to be
entered as shown
