![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-3210-series/iplink-3210-series_getting-started-manual_4070846091.webp)
Status LEDs
91
IPLink 3210 Series Getting Started Guide
8 • LEDs status and monitoring
Status LEDs
This chapter describes IPLink gateway router front panel LEDs.
Figure 23
shows IPLink 3210 Series LEDs.
LED definitions are listed in
table 15
on page 91.
Figure 23. Examples of IPLink 3210 Series front panels
Table 15. IPLink LED Indications
LED
Description
Note
If an error occurs, all LEDs will flash once per second.
Power
When lit, indicates power is applied. Off indicates no power applied.
Run
When lit, indicates normal operation. Flashes once per second during boot (startup).
Ethernet (each port)
• Link: Lit when Ethernet link is up.
• 100M: On when 100-Mbps Ethernet is selected.
• Activity: Flashes when data is received or transmitted from the unit to the LAN.
WAN (Rear panel)
• STATUS: Lit when serial link is up.
• ACTIVITY: Flashes when serial data is transmitted or received from the unit.
Link
100M
Activity
Enet 0
IPLink VPN
Router
Run
Link
100M
Activity
Enet 1
P
ower
Console
Link 100M Activity
Enet 0
Console
IPLink VPN Router
Run
Link 100M Activity
Enet 1
IPLink 3210
Power
Console port
Summary of Contents for IPLink 3210 Series
