![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-3210-series/iplink-3210-series_getting-started-manual_4070846031.webp)
Installing the VPN router
31
IPLink 3210 Series Getting Started Guide
2 • Hardware installation
figure 7
). Ethernet devices (10Base-T or 100Base-T) are connected to the IPLink’s Ethernet ports (see
table 5
for port pin-out listing) via a cable terminated with RJ-45 plugs.
Note
Pins not listed are not used.
Figure 7. Connecting an IPLink 3210 Series device to a hub
Installing the DSL cable
The IPLink 3210 comes with a G.SHDSL interface. Use a straight-through RJ-11 cable to connect the DSL
port.
Table 5. Ethernet 10/100Base-T (RJ-45) port pin-outs
Pin
Signal
1
TX+
2
TX-
3
RX+
6
RX-
Hub
Straight-through cable
RJ-45, male
Tx+
Tx-
Rx+
Rx-
1
2
3
6
RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
Summary of Contents for IPLink 3210 Series
