![background image](http://html1.mh-extra.com/html/patton-electronics/iplink-3210-series/iplink-3210-series_getting-started-manual_4070846065.webp)
Access control list configuration task list
65
IPLink 3210 Series Getting Started Guide
6 • Access control list configuration
The same effect can also be obtained by using the simpler message name option. See the following example.
3210(cfg)#profile acl WanRx
3210(pf-acl)[WanRX]#deny icmp any any msg echo
3210(pf-acl)[WanRX]#exit
3210(cfg)#
Adding a TCP, UDP or SCTP filter rule to the current access control list profile
The commands
permit
or
deny
are used to define a TCP, UDP or SCTP filter rule. Each TCP, UDP or SCTP
filter rule represents a respective access of control list entry.
This procedure describes how to create a TCP, UDP or SCTP access control list entry that permits access
Mode: Profile access control list
This procedure describes how to create a TCP, UDP or SCTP access control list entry that denies access
Mode: Profile access control list
Step
Command
Purpose
1
node(pf-acl)[
name
]#permit {tcp | udp | sctp} {
src src-wild-
card
| any | host
src
} [{eq
port
| gt
port
| lt
port
| range
from to
}] {
dest dest-wildcard
| any | host
dest
} [{eq
port
| gt
port
| lt
port
| range
from to
}] [{cos
group
| cos-rtp
group-
data group-ctrl
}]
Creates a TCP, UDP or SCTP
access of control list entry that
permits access defined according
to the command options
Step
Command
Purpose
1
node(pf-acl)[
name
]#deny {tcp | udp | sctp} {
src src-
wildcard
| any | host
src
} [{eq
port
| gt
port
| lt
port
|
range
from to
}] {
dest dest-wildcard
| any | host
dest
} [{eq
port
| gt
port
| lt
port
| range
from to
}] [{cos
group
| cos-
rtp
group-data group-ctrl
}]
Creates a TCP, UDP or SCTP
access of control list entry that
denies access defined according
to the command options
Summary of Contents for IPLink 3210 Series
