Configuring SDH
135
FS6300 NMS User Manual
8 • Configuring the 6511RC Card
Configuring SDH
Click on
SDH Configuration
to bring up the SDH Configuration window to view and modify SDH inter-
faces and paths.
Configuring SDH Interfaces
To configure SDH interfaces:
1.
Click on
View/Modify SDH Configuration
in the menu tree of the SDH Configuration window.
Figure 119. 6511RC SDH Interface Configuration
2.
Select a
Physical Interface
from the drop-down menu under SDH Physical Configuration, and click
Sub-
mit
. The
Physical Interface
corresponds to the physical cabling atatched to the STM-1 interface ports.
Select
Optical
if you are using fiber-optic cable connected to the rear-card SC connectors.
Select
Electrical
if you are using coaxial cables connected to the rear-card BNC connectors.
3.
If desired, enter an alphanumeric name for the STM-1 link in the
Circuit Identifier
field.
4.
If section trace is enabled in your connected SDH network, select
sectionTraceEnable
from the
Section
Trace Monitor
drop-down menu. Otherwise, select
sectionTraceDisable
, and go to Step 8 on
page 136
.
5.
If the Section Trace Monitor is Enabled, enter the alphanumeric name your connected SDH network uses
for the
Section Trace
message in the SDH frame.
