Paton ProMIG-200, User Manual

Page: 118 / 130

- 117 -
PATON ProMIG DC MMA/TIG/MIG/MAG
If the menu is locked, as is the case with the function menu on the source, simply
hold this button for more than 3.5 seconds
6.2 SWITCHING TO THE REQUIRED WELDING MODE
Pressing button 4 leads to switching to the next welding mode in a circle, this can
be seen on display 1 on the front panel.
6.3 RESET ALL FUNCTIONS OF THE WELDING MODE USED
Situations may occur when the unit's settings have somewhat confused the user. In
order to reset their values to the factory default, use the same button 3 , used to enter the
function menu. To reset the settings, simply hold down button 3 for more than 10 seconds
(ignore the animation of locks). The scoreboard will start counting down 333...222...111 and
when "000" is reached, all settings of the current welding mode will be updated to factory
settings. Resetting parameters for each welding mode is performed separately! This is
provided for convenience, so as not to accidentally reset individual settings in the other two
modes.
Similarly, you can reset the parameters on the wire feeder using button 10 .
6.4 CHANGE THE PROGRAM NUMBER IN THE CURRENT WELDING MODE
In each MMA, TIG and MIG/MAG welding mode, the user can save up to 16 different
settings. The current preset (program) number is displayed in the upper right corner of the
indicator of the source on the front panel. When the unit is turned on for the first time, the
program is always No. 1 for each welding mode. All changes in the setting of the unit in this
welding mode and the current program number are saved. To switch to another program
number and start setting again from the basic parameters, simply press button
3 , and if the
function selection menu is locked, then the indicator displays the current program number,
which can be changed up or down using buttons
2 . If the function selection menu is not
locked, e.g.: just before that the user changed the additional parameters of the functions
described in paragraph 6.1, then it is necessary to lock the function selection menu by
holding button
3 for more than 3.5 seconds, just like when unlocking, in this case, the closing
locks animation will be displayed on the indicator. When this operation is completed, the
menu will be locked, and now you can try again to change the program number using
button
3 . In this case, all parameters of the previous program will be saved and you can
always return to it at any time.
7. GENERAL LIST AND SEQUENCE OF FUNCTIONS
MMA welding mode
0) [- 1 -] - main displayed parameter CURRENT = 90A (by default)
a) 8 ... 160А (change step 1А) for ProMIG -160
b) 10 ... 200А (change step 1А) for ProMIG -200
c) 12 ... 250А (change step 1А) for ProMIG -250