Paton ProMIG-200, User Manual

Page: 119 / 130

PATON ProMIG DC MMA/TIG/MIG/MAG
- 118 -
d) 12 ... 270A (change step 1A) for ProMIG-270
e) 14 ... 350А (change step 1А) for ProMIG -350
f) 16 ... 500А (change step 1А) for ProMIG -500
g) 18 ... 630А (change step 1А) for ProMIG -630
1) [H.St] Hot start power = 40% (by default)
a) 0[OFF] ... 100% (change step 5%)
2) [t.HS] Hot start time = 0.3 sec (by default)
a) 0.1 ... 1.0 sec (change step 0.1 sec)
3) [Ar.F] Arc Force power = 40% (by default)
a) 0[OFF] ... 100% (change step 5%)
4) [u.AF] Arc force trigger level = 12V (by default)
a) 9 ... 18V (change step 1V)
5) [CVS] current-voltage characteristic slope = 1.4 V/A (by default)
a) 0.2 ... 1.8 V/A (step change 0.4 V/A)
6) [Sh.A] short arc welding = OFF (by default)
a) ON – enabled
b) OFF – disabled
7) [BSn] voltage reduction unit = OFF (by default)
a) ON – enabled
b) OFF – disabled
8) [Po.P] current pulsation power = OFF (by default)
a) 0[OFF] ... 80% (change step 5%)
9) [Fr.P] current pulsation frequency = 5.0 Hz (by default)
a) 0.2 ... 500 Hz (dynamic change step 0.1 Hz ... 1 Hz)
10) [dut] pulse/pause ratio (duty cycle) - it is the percentage of the larger current pulse to
the period of repetition of these pulses = 50% (by default)
a) 20 ... 80% (change step 5%)
TIG welding mode
0) [-2-] main display parameter CURRENT = 100A (by default)
a) 8 ... 160А (change step 1А) for ProMIG -160
b) 10 ... 200А (change step 1А) for ProMIG-200
c) 12 ... 250А (change step 1А) for ProMIG -250
d) 12 ... 270A (change step 1A) for ProMIG-270
e) 14 ... 350А (change step 1А) for ProMIG -350
f) 16 ... 500А (change step 1А) for ProMIG -500
g) 18 ... 630А (change step 1А) for ProMIG -630
1) [But] torch button mode = [2T] (by default)
a) [LIFT] - contact striking mode TIG-LIFT
b) [2T] - non-contact striking mode, TIG-2T button mode
c) [4T] - non-contact striking mode, TIG-4T button mode