Paton ProMIG-200, User Manual

Page: 122 / 130

- 121 -
PATON ProMIG DC MMA/TIG/MIG/MAG
6) [t.dn] wire feed speed ramp-down time = OFF (by default)
a) 0 [OFF] ... 5.0 sec (change step 0.1 sec)
8. GENERATOR OPERATION
The power supply is suitable for generator operation, provided as follows:
When working with
an electrode
Set current value for
MMA and TIG
When working with wire diameter
of
MIG/MAG
Minimum generator
power
Ø 2 not more than 80А not more than Ø 0.6 mm 3.0 kVA
Ø3 not more than 120А not more than Ø 0.8 mm 4.5 kVA
Ø 4 not more than 160А not more than Ø 1.0 mm 6.0 kVA
Ø 5 not more than 200А not more than Ø 1.0 mm 7.7 kVA
Ø 6 fusible not more than 250A not more than Ø 1.2 mm 10 kVA
Ø 6 fusible not more than 270А not more than Ø 1.2 mm 12.0 kVA
Ø 6 not more than 350А not more than Ø 1.4 mm 16.0 kVA
Ø 8 fusible not more than 500А not more than Ø 1.6 mm 30.5 kVA
Ø 8 up to 630A not more than Ø 2.0 mm 42.0 kVA
For trouble-free operation! The output line-to-line voltage of the generator must not
exceed the permissible limits:
- 160-260V (for ProMIG-160/200/250);
- 320-440V for all three phases (for ProMIG-270/350/500/630).
9. CARE AND MAINTENANCE
Caution! Before opening the unit, be sure to turn it off, disconnect the mains plug.
Allow the internal circuits of the unit to discharge (about 5 minutes), and only then proceed
to other actions. When leaving, install a sign prohibiting to start the unit.
In order to keep the unit operational for many years, be sure to follow several rules:
- carry out a safety inspection at specified intervals (see Section "Safety instructions");
- with intensive use, we recommend that you blow the unit with dry compressed air every
six months. Caution! Blowing from a short distance can result in damage to the electronic
components;
- if there is a lot of dust, clean the cooling system ducts manually.
10. STORAGE
Store the conserved and packaged source under storage conditions 4 in accordance
with GOST 15150-69 for a period of up to 5 years.