July 2021
65
PWVIA RM P12 Ethernet Switches - Manual
VLAN CONFIG/STATUS: NETWORK SETUP
This menu operates the same as the switch’s main
Network Setup
menu. Configure these for each VLAN ID#.
Network Setup
IP Mode: Static
IP Address: X.X.X.X
Subnet Mask: X.X.X.X
Gateway: X.X.X.X
<Back>
Menu Item
Description
IP Mode
Determines how IP settings will be obtained.
Disabled (default)
: No IP assigned.
Static
: IP Settings manually set by user.
Dynamic
: IP Settings will be obtained from a DHCP server.
<Back>
: Return to previous menu
IP Address
Manually sets IP address (IPv4).
Turn encoder to set each octet. Push to accept and move to next octet. Illegal values
are not accepted.
Subnet Mask
Set subnet mask for VLAN. Only valid masks are shown.
Turn knob to select from list of valid masks.
Gateway
Set default gateway for VLAN. Only valid gateways are accepted.
Turn knob to set each octet. Push to accept. Illegal values are not shown. Gateway
setup is needed for Internet access for SixEye Remote Monitoring and Management.
<Back>
Return to previous menu.
Network Settings must be configured on all VLAN requiring use of multicast filtering (IGMP) or a DHCP server. By default,
only the management VLAN (VLAN ID#1 by default) is automatically assigned an IP and subnet mask. All other VLANs
default to a null IP address value (0.0.0.0). From the Network Settings for each VLAN, assign a unique IP per switch, a
common subnet mask and, where necessary, a default gateway.
Typically, Internet access will be through a proxy or NAT gateway, in which case the default gateway IP should point to this
device.
IP Mode must be set to “Static” if the VIA is to act as a DHCP server. Only one DHCP server may be active on any given
VLAN. Setting the IP Mode to “Dynamic” does NOT enable the DHCP server – see below.
Summary of Contents for VIA PWVIA RM P12
Page 7: ......
Page 89: ...PWVIA RM P12 Ethernet Switches Manual July 2021 82...
