Assembly
10
Lift the empty styrofoam blocks and the body of the
machine out of the box.
Align the machine with the front table edge in such a
way that the machine slightly slopes to the back.
At each end fit the feeding eyelet supports underneath
the needle bed. The illustration shows the left half of
the needle bed as seen from the back. Look at this
backview of the needle bed. You will see four screws
that fit into round plastic pins. Insert the feeding eyelet
support between the second and the third screw, at
the same time depressing the small latch on the
feeding eyelet support. Make sure the support clicks
into place.
t
11
From the side insert the row counter into its
support-rail exactly as shown in the illustration.
If this has been done correctly, the row counter will not
touch the table when the machine is in its correct
position.
Now fasten the needle bed to the table edge using the
two clamps.
4
