PS-3220
Set-up
7
013-16067A
the old battery, installing a new battery of the same type, and replacing the Battery Compartment Cover. The
procedure needs a coin and a CR2032 three volt battery.
•
(NOTE: This battery is available from PASCO and in electronic and commercial stores.)
Remove the Battery Compartment Cover
•
Hold the sensor bottom-side up. Use a coin in the slot to turn the Battery
Compartment Cover counterclockwise (left-to-right) until the indicator on the
door is aligned with the second mark on the sensor.
•
Turn the sensor bottom-side down so that the Battery Compartment Cover can
drop into the palm of your hand. Make sure that the battery cover gasket stays
on the cover. The gasket is an “O-ring” that is held in place by the tabs on the
cover. Please do not touch the inside of the battery compartment
•
Remove the used battery from the Battery Compartment Cover and replace it with a new identical type battery.
Note that the battery is held in place by the small tabs on the cover. The side of the battery with the “+” on it
should be against the cover.
Replace the Battery Compartment Cover
•
Put the Battery Compartment Door with the new battery back onto the sensor. Align the
indicator on the cover with the second mark, and use the coin in the slot to turn the
cover clockwise (right-to-left) until the indicator is aligned with the first mark on the
sensor.
(See “Battery Disposal Instructions” under Technical Support.)
Related Item
•
Coin-cell Battery Replacement Pack (10 pack) - PS-3504
See the PASCO web site at www.pasco.com for more information.
Troubleshooting the Wireless Temperature Link
•
If the sensor loses Bluetooth connection and will not reconnect, try cycling the ON button. Press and briefly
hold the button until the status LEDs blink, and then release the button
•
If the sensor stops communicating with the computer software or tablet application, try restarting the software
or application. If the problem remains, press and hold the ON button for ten seconds and then release the
button. Turn on the sensor in the usual way.
Second mark
Coin
slot
Battery
Compartment
Cove
Gasket (“O”-ring)
Battery (CR2032)
Tab
PLEASE Do Not Touch
First mark
