Partner PT-5700, User Manual

Page: 24 / 60

14 Chapter 2 Upgrading Components
Before you begin
Make sure you have a stable, clean working environment. Dust and dirt can get into components and cause a malfunc-
tion. Adequate lighting and proper tools can prevent you from accidentally damaging the internal components.
Most of the electrical and mechanical connections can be disconnected by using your fingers. It is recommended that
you do not use needle-nosed pliers to disconnect connectors as these can damage the soft metal or plastic parts of the
connectors.
Installing a hard disk drive (HDD)
Refer to the following to install a HDD.
CAUTION
To prevent scratching the case of the PT-5700, make sure the worktop surface is
clean and flat.
1
Remove the rear cover. See “Removing the
rear cover” on page 6.
2
Remove the quick release screw from the
HDD bracket.
3
Remove the bracket.
4
Attach the HDD to the bracket with 4
screws.
5
Attach the two cables.
6
Put the bracket back into place.
7
Replace the quick release screw.
NOTE
Refer to the documentation with the replacement drive for instructions on set-
ting drive jumpers and formatting the drive.