Partner PT-5700, User Manual

Page: 56 / 60

46 Appendix
Beep Message Errors at POST
If the BIOS detects an error during the POST, a message is displayed. Refer to the following table for a list of the errors
that display.
WARNING
The system uses a 3V CR2032 battery (CMOS battery) mounted on the main-
board to keep time. There is a risk of explosion if the wrong battery type is used
when replacing. Dispose of used batteries according to local ordinance regula-
tions.
E
RROR
M
ESSAGE
C
AUSE
S
OLUTION
CMOS BATTERY HAS
FAILED The CMOS battery is depleted. Replace the battery.
CMOS CHECKSUM ERROR The battery may be weak.
The CMOS may be corrupt.
Replace the battery.
Have the PT-5700 serviced.
DISPLAY SWITCH IS SET
INCORRECTLY The display switch setting on the main-
board is different to the setting in the
BIOS Setup. Have the PT-5700 serviced.
FLOPPY DISK(S) FAIL (80) Unable to reset floppy subsystem. Have the PT-5700 serviced.
FLOPPY DISK(S) FAIL (40) Floppy type mismatch. Have the PT-5700 serviced.
HARD DISK(S) FAIL (80) HDD reset failed. Have the PT-5700 serviced.
HARD DISK(S) FAIL (40) HDD controller diagnostics failed. Have the PT-5700 serviced.
HARD DISK(S) FAIL (20) HDD initialization error. Have the PT-5700 serviced.
HARD DISK(S) FAIL (10) Unable to recalibrate fixed disk. Have the PT-5700 serviced.
KEYBOARD IS LOCKED OUT
- UNLOCK THE KEY The keyboard is locked and the key-
board controller is pulled low. Have the PT-5700 serviced.
KEYBOARD ERROR OR NO
KEYBOARD PRESENT A keyboard is not detected. Make sure the keyboard is
attached correctly and no
key is pressed during boot.
MANUFACTURING
POST LOOP System keeps rebooting because the
keyboard controller is pulled low for test-
ing purposes. Have the PT-5700 serviced.
BIOS ROM CHECKSUM
ERROR - SYSTEM HALTED The ROM address is incorrect. Have the PT-5700 serviced.
MEMORY TEST FAIL The memory card is not correctly
installed or is damaged. Have the PT-5700 serviced.