PAR POS Installation Manual for TACO DEL MAR
Page
16
Verify all Cables are Connected to the Terminal
All necessary cables and your power supply have been connected to the POS terminal. Verify that the MSR
card reader, Customer Display and DC power cord are all connected as shown below.
Figure 32: From left: PS2 MSR, Customer Display and Power cable ports
Gather the Cables and Replace Cable Retainers
1.
Gather the cables in one hand and replace the cable retainer, securing the cables neatly in place.
Ensure the cables are not kinked or stressed.
2.
Stand the POS upright on its base. We will now connect your remaining POS peripherals.
Figure 33: Gather the cables
Install Pedestal Cover and I/O Panel
1.
Slide the cover pedestal
cover into position and
tighten the two thumb
screws.
2.
Slide the cut out into the
base of the terminal and
snap into place.
3.
Slide the I/O panel cover
into position.
Figure 34: Install pedestal and I/O panel cover
Install I/O Panel
Cover
Install Pedestal Cover
Install cut out cover
Gather Cables the cables together
and route them through the cable
clamps
