PDMFG 180 A1
■
32
│
GB
│
MT
♦
Then, turn the attachment using slight force until
the lock engages on the tool.
Removing the attachment
♦
To remove the respective attachment, pull the
locking ring downward.
♦
Then, twist and pull out the attachment.
Operation
Compressed air ratchet
♦
Put the required plug-in attachment onto the
square retainer .
♦
Set the correct rotational direction on the turn
bolt :
R = anticlockwise
F = clockwise
♦
Fit the plug-in attachment onto the
screw head.
NOTE
►
The connection with the compressed air
source is made using a flexible compressed
air hose with a quick coupler.
You will reach the best performance of your
ratchet wrench with a compressed air hose
LW 10 mm.
Compressed air drill
Insert bit or drill:
♦
Open the wheel-rim chuck using the wrench
.
♦
Now insert the drill as deeply as possible into
the wheel-rim chuck .
♦
To clamp the drill, close the wheel-rim chuck
using the wrench . Ensure the drill is firmly
attached.
Compressed air precision drill grinder
Fitting a tool:
CAUTION!
►
The shaft diameter of the tool must exactly
match the clamp bore of the collet chuck
(Ø 6.35 mm)!
♦
Insert the tool in the collet chuck .
♦
Hold the spindle using the assembly tool .
♦
Tighten the collet chuck nut using the assem-
bly tool .
■
Ensure the accessory tool is firmly attached.
CAUTION!
►
If no tool is inserted in the collet chuck ,
do not tighten the collet chuck nut
with the
assembly tool , screw it on by hand only!
Switching on and off
Switching on:
♦
First, press the trigger lock and then the
trigger forwards to switch the tool on.
Switching off:
♦
Release the trigger .
♦
When you have finished working, disconnect
the tool from the compressed air source.
Summary of Contents for PDMFG 180 A1
Page 3: ......