![background image](http://html1.mh-extra.com/html/parkside/pdmfg-180-a1/pdmfg-180-a1_translation-of-the-original-instructions_4083808030.webp)
PDMFG 180 A1
GB
│
MT
│
27
■
■
Use personal protective equipment. Always
wear eye protection. Wearing personal pro-
tective equipment such as protective gloves,
non-slip safety shoes or hearing protection,
depending on the type and use of the power
tool reduces the risk of personal injuries and it is
recommended.
■
The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed air tool.
Accessories that rotate faster than permissible
can break and become airborne.
■
Wear a safety helmet for overhead work.
■
The tool will run on after the compressed air
tool has been switched off.
■
Ensure that no hazard is caused by sparks
created during use. Explosive or flammable
dusts can be created when processing certain
materials. There is a risk of explosion or fire.
Hazards caused by repetitive move-
ments
■
Users of an automatic screwdriver may experi-
ence unpleasant sensations in their hands, arms,
shoulders, neck area or other body parts while
working with the tools.
■
Assume a comfortable position when working
with this machine, pay attention to safe footing
and avoid unfavourable positions or such that
make it difficult to keep your balance. During
work over longer periods, the operator should
change posture to avoid discomfort and fatigue.
■
If the operator notices symptoms such as persis-
tent discomfort, throbbing, pain, tingling, burn-
ing or stiffness, these warning indications should
not be ignored. The operator should consult a
qualified medical doctor.
Hazards caused by accessories
■
Disconnect the machine from the energy supply
before changing the machine tool or accessory.
■
Do not touch fittings or accessories during the
striking process because this can increase the
risk of cuts, burns or injuries caused by vibra-
tions.
■
Avoid direct contact with the accessory tool
during and after use because it may be hot or
have sharp edges.
■
Use only accessories and supplies of the sizes
and types recommended by the manufacturer
of machines for screw connections; do not use
any other types or sizes of accessories or con-
sumable materials.
■
Use only impact fittings that are in good working
order because any defects in the handles and
accessories can cause these to break and be
ejected when used with impact wrenches.
■
The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the compressed air tool.
Accessories that rotate faster than permissible
can break and become airborne.
■
Never fit a grinding disc, cutting disc or milling
cutter. A bursting grinding disc can lead to seri-
ous injuries or death.
■
Do not use discs that are damaged, cracked or
have been dropped.
■
Only approved accessory tools with the appro-
priate shaft diameter may be used.
■
Observe the manufacturer's recommendation
for small grinding tools. The maximum permissi-
ble protrusion (L0 = length of the shaft between
the collet chuck end and the small grinding
tool) specified by the manufacturer must not be
exceeded when using small grinding tools! If
the protrusion (L0) is increased, the permissible
rotation speed must be lowered. Wherever pos-
sible, insert the complete length of the shaft of
the accessory tool into the collet chuck. Ensure
that the clamping length (Lg) is at least 10 mm.
Lo
L
g
■
The shaft diameter of the accessory tool must
exactly match the clamp bore of the collet chuck!
Summary of Contents for PDMFG 180 A1
Page 3: ......