![background image](http://html1.mh-extra.com/html/parkside/pdmfg-180-a1/pdmfg-180-a1_translation-of-the-original-instructions_4083808027.webp)
PDMFG 180 A1
■
24
│
GB
│
MT
■
Protect the hoses against kinking, constriction,
solvents and sharp edges. Keep hoses away
from heat, oil and rotating parts.
■
Ensure that the hose clamps are always tight-
ened firmly. Loose or damaged hose clamps
can allow air to escape in an uncontrolled
manner.
■
Replace a damaged hose immediately. A defec-
tive supply line can cause a compressed air
hose to thrash about and cause personal injury.
■
If the power cable of this tool is damaged, it
must be replaced by the manufacturer or its cus-
tomer service or by a similarly qualified person
in order to avoid hazards.
■
Do not use the tool if you are tired or under the
influence of drugs, alcohol or medication.
A moment of inattention when operating the
tool can result in serious personal injury.
■
Do not breathe in the exhaust air directly. Avoid
getting exhaust air in your eyes. The exhaust air
from the compressed air tool can contain water,
oil, metal particles or dirt from the compressor.
This can cause damage to health.
WARNING!
►
BE CAREFUL WHEN PUTTING DOWN THE
TOOL! Always put the tool down in such a
way that it does not lie on the trigger. Under
certain circumstances, this might cause an
accidental activation of the tool, which in turn
might lead to hazards.
■
Only suitable accessories may be used.
You can purchase these from the manufacturer.
Accessories other than original equipment can
cause hazards.
■
Use only filtered and regulated compressed
air. Dust, caustic fumes and/or moisture can
damage the motor of a compressed air tool.
■
The hose must be designed for min. 6.3 bar
or 125 psi, at least for 150% of the maximum
pressure generated in the system.
■
The tool and the supply hose must be fitted with
a hose coupling that allows the pressure of
the coupling hole to be dispersed completely
during disconnection.
■
DANGER! Avoid contact with an energised line!
This tool is not insulated against electric shock.
WARNING! RISK OF INJURY!
►
At high working pressures, kickback can
occur under certain circumstances that can
cause hazards due to continuous loads.
■
If you are inexperienced with the appliance,
seek training in how to use it safely.
WARNING! RISK OF INJURY!
►
RISK OF PUNCTURE WOUNDS! Do not
treat an injection as a simple cut. A high-
pressure jet can inject toxins into the body
and cause serious injuries. In the event of an
injection into the skin, seek medical assistance
immediately.
■
The compressed air tool must not be modified in
any way without the manufacturer's approval.
■
Use the compressed air tool only with the speci-
fied pressure (6.3 bar).
■
The compressed air tool must always be discon-
nected from the air supply after use and for as
long as it is not in use.
■
The compressed air tool must not be used if it is
not airtight or if it requires repair.
■
Never connect the compressed air tool with a
compressed air hose that exceeds a pressure
of 6.3 bar.
Summary of Contents for PDMFG 180 A1
Page 3: ......