background image

5 V 

2,1 A

 power supply unit for electronic device • 1 front USB output • power 100-230V ~  50/60 Hz - 1 module •

The device is used for charging mobile phones and electronic devices that offer the feature of charging via a standard USB port.
WARNING:

▶  

Refer to the instructions manual of the device to charge in order to ascertain whether it can be used with the power supply question.

▶  

Sometimes type of old generation Ipods are not suited to be used with the power supply; the device might therefore not be able to be charged correcly.

CHARACTERISTICS:

▶  

Power: 100-230 V ~ 50/60 Hz

▶  

Consumption: 300 mA a 100 V ~ 

 

150 mA a 230 V ~

▶  

Output voltage: 5 V 

 (± 5%) SELV

▶  

Maximum load output: 2,1 A

▶  

Performance: maximum of 77% (Energy Star EPS v.2)

▶  

No load consumption: 30 mW

▶  

Degree of protection: IP20

▶  

Operating pempterature: 0°C/+45°C (indoor)

▶  

Class device II

▶  

Overvoltage category (EN 62109): Class III

▶  

Device with a contact gap of at least 3mm

INSTALLATION RULES:

Do not install more than one power suppliers side by side. it’s  suggested to keep empty the module near by the USB power supplier.

Installation should be carried out in compliance with the current regulations regarding the installation of electrical system in the country where the products are installed. 

The device must be installed in flush or surface mounting boxes with Eikon or Plana mounting frame and cover plates, in places that aare not dusty, 

that are protected from accidental knocks and are far from sources of heat.
IMPORTANT:

An easily accessible cut-off switch must be installed upstream from the power supply.

The lenght of the cable for connecting to the telephone must be less than 3 m.

The power supply is protected internally against overload.
CONFORMITY: 

Direttiva BT., Direttiva EMC., EN 60950-1

Unità di alimentazione 5 V 2,1 A per dispositivi elettronici • 1 uscita USB frontale • alimentazione 100-230V ~  50/60 Hz - 1 modulo •

Il dispositivo va utilizzato per ricaricare i telefoni cellulari e tutti gli apparecchi elettronici che offrono la possibilità di ricarica da una qualsiasi presa standard USB.
ATTENZIONE:

▶  

Consultare il manuale istruzioni dell’apparecchio da ricaricare per accertarsi che possa essere utilizzato con l’alimentatore in oggetto.

▶  

Alcuni tipi di iPod di vecchia generazione non sono adatti per essere utilizzati con l’alimentatore; la ricarica del dispositivo potrebbe quindi non avvenire correttamente.

CARATTERISTICHE:

▶  

Alimentazione: 100-230 V ~ 50/60 Hz

▶  

Consumo: 300 mA a 100 V ~ 

 

150 mA a 230 V ~ 

▶  

Tensione di uscita: 5 V 

 (± 5%) SELV

▶  

Carico max in uscita: 2,1 A

▶  

Rendimento: maggiore del 77% (Energy Star EPS v.2)

▶  

Consumo a vuoto: 30 mW

▶  

Grado di protezione: IP20

▶  

Temperatura di funzionamento: 0° C/+45° C (uso interno)

▶  

Apparecchio di classe II

▶  

Categoria di sovratensione (EN 62109): Classe III

▶  

Dispositivo di sezionamento con distanza  fra i contatti di almeno 3mm

REGOLE D’INSTALLAZIONE:

Non installare più alimentatori affiancati. Si consiglia di lasciare libero il modulo adiacente l’alimentatore USB.

L’installazione deve essere effettuata con l’osservanza delle disposizioni regolanti l’installazione del materiale elettrico in vigore nel paese dive i prodotti sono installati. 

L’apparecchio deve essere installato in scatole da incasso o da parete con supporti e placche compatibili con la serie civile indicata sull’etichetta, in luoghi non polverosi, 

protetto da urti accidentali e lontano da fonti di calore.
IMPORTANTE:

A monte dell’alimentatore deve essere installato un interruttore di sezionamento facilmente accessibile. 

La lunghezza del cavo per collegamento al telefono deve essere inferiore a 3m.

L’alimentatore è protetto internamente contro i sovraccarichi.
CONFORMITÀ NORMATIVE: 

Direttiva BT., Direttiva EMC., EN 60950-1

CODICI PRODOTTO: 4B.AM.USB, 4B.L.USB, 4B.N.USB,4B.NT.USB, 4B.HS.USB, 4B.HC.USB, 4B.HD.USB, 4B.V14.USB, 4B.G10.USB

4box.it

4 BOX s.r.l.

VAT IT07624080961

sede legale: 
P.le 

Segesta 15 

I-20148 Milano

sede operativa:

 

V.le 

Pasubio 6 

I-20121 Milano

 

[email protected] 

+39 

02 65 560 373

+39 

02 45 498 295

Cod. fisc. e iscrizione al reg. impr: 07624080961 - R.E.A. 1972154 - C.C.I.A.A. MI - Cap. Soc. € 20.000

4box. The electric revolution.

PRODUCT CODES: 4B.AM.USB, 4B.L.USB, 4B.N.USB,4B.NT.USB, 4B.HS.USB, 4B.HC.USB, 4B.HD.USB, 4B.V14.USB, 4B.G10.USB

Reviews: