Parking Facilities PF6000X, Installation, Operation & Maintenance Manual

Page: 19 / 38

When a number or letter is shaded this denotes that input is active. So if something below should be normally closed then when shaded this is
in its normal state. If a normally closed input is unshaded then this denotes that the circuit has gone open and the input is active.
For instance if IE is shaded with a box then the photocells are in a normal state and the barrier would lower. If this becomes UN-shaded then
the photocell beam has been blocked so the barrier will no longer lower.
(if you have a separate safety edge module then input just for photocells)
(Door Safety Switch/External Stop Button)
PF6000X PLC Logic
Menu/Ok
SR2 B121BD
1
2
Q1
1
2
Q2
1
2
Q3
1
2
Q4
+
-
I1 I2 I3 I4 IB ID IC IE
24VDC
24VDC 24VDC Analog or
IB....IE Inputs I1...I4
Outputs
Q1...Q4 : Relay 8A
1. Inputs
Input Polarity Connected to Operation when active
I1 Normally Closed Stop Circuit Stop Circuit Active
I2 Normally Open Raise/Open signal Barrier is getting a PERMANENT open signal
I3 Normally Open Lower/Close signal Lowers barrier (Barrier is getting a permanent Close Signal)
I4 Normally Closed Raise Limit Barrier arm has reached fully open position. Upper limit switch active
IB Normally Closed Loop detector/Safety loop Detecting vehicle on safety loop. Lowers when vehicle is not detected
IC Normally Open Free entry/Free exit loop Detecting vehicle on free exit/entry loop/ Barrier opens when vehicle present on loop
ID Normally Closed Lower limit Arm has reached fully closed position. Lower limit switch active
IE Normally Closed Safety Edge Input /Photocell Input Photocell Active or Safety Edge Active
2. Outputs
Output: Polarity: Connected to: Operation when active:
Q1 Normally Open Motor controller open direction Active to open barrier
Q2 Normally Open Motor controller close direction Active to close barrier
Q3 Normally Open Boom light or Magnetic arm lock Signal given to accessories
Q4 Normally Open Flashing beacon/Siren (if installed in
program) Signal given to accessory if installed in PLC program
The table (bottom) relates to the diagram directly below to help you trouble shoot electrical component errors
Menu/Ok
SR2 B121BD
1
2
Q1
1
2
Q2
1
2
Q3
1
2
Q4
+
-
I1 I2 I3 I4 IB ID IC IE
24VDC
24VDC 24VDC Analog or
IB....IE Inputs I1...I4
Outputs
Q1...Q4 : Relay 8A
1. 2.
1 B 234 CDE
RUN LD
SUN 20 JUL 09:36
1234
1234 BCDE
STOP LD
SUN 20 JUL 09:37
1 3 2 4
Input displays
which change
as inputs used
detailed in the
table below.
Example
showing number
I1 and IB input
selected
Showing program in “run mode” Showing program in “Stop mode”
Output displays
which change
as Outputs used
detailed in the
table below.
Example
showing number
Q1 and Q3
output selected
Date/Time Display Date/Time Display
Note:
If barriers are set up as a master and slave then see additional wiring info in this section.
!