Parker Hannifin Corporation
Gear Pump Division
Kings Mountain, North Carolina USA
9
Start Assembly Here
2) Place a new shaft
seal on the installation
tool with the spring side
facing outward.
5) Check the section
seal. Use of a new one
is recommended in each
case. Grease the new
section seal to hold it in
the groove.
3) Press seal to a depth that
is just deep enough to allow
installation of the snap ring.
1) Clean seal bore
thoroughly. When
installing metal OD
seals apply adhesive
to the seal OD and the
bore ID. Rubber OD
seals do not require
adhesive, instead a
lubricant should be
used on the OD.
4) Assemble the
snap ring. A new snap
ring should be used if
supplied in the seal kit.
Catalog HY09-SM500/US
Assembly Information
PGP/PGM500 Series
Service Manual
