Parker Hannifin Corporation
Gear Pump Division
Kings Mountain, North Carolina USA
11
Catalog HY09-SM500/US
Assembly Information
PGP/PGM500 Series
Service Manual
PGP/PGM505
23 lb-ft
31 Nm
PGP/PGM511
36 lb-ft
49 Nm
FASTENER TORQUE
15) Install port
end cover.
13) Install section seal.
Use grease to hold into
groove.
16)
Install hardware (bolts
and washers). Thread
the fasteners into the
mounting flange and
tighten alternately or
cross corner. Torque
diagonally opposed
fasteners to correct
torque. Do not lubricate
fastener threads before
assembly.
14) Install rear thrust
block. Direction is
important.
12) Install gear housing.
10) Insert shaft fully
through mounting
flange and remove
sleeve.
11) Install idler gear
into thrust block and
mounting flange.
