Parker HLR070, Mounting Instructions

Page: 43 / 56

Parker EME Steel strip cover disassembly and replacement
192-510201N1 HLR 2019-04
43
5.4 Steel strip cover disassembly and replacement
Steel strip cover is sharp-edged. If handled carelessly during maintenance, you
might cut yourself. Protection gloves must be worn!
After dismantelling the carriage lid, the frontal stop surface of the carriage is
sharp-edged. If handled carelessly during maintenance, you might cut yourself.
Protection gloves must be worn!
The steel strip cover used does not have to be changed over the entire service life
of the linear axis, taking into account the technical axis data and boundary
conditions. However, due to external influences or misuse, the steel strip cover
may be damaged (scratches, dents or cracks) in these cases the cover must be
replaced.
Dismantling and assembly procedure
Figure 13: Disassembly of steel strip cover
Deflection station and carriage lid must be accessible for the following steps.
Dismantle parts and loads if necessary.

Position the carriage in the middle of the profile.

Loosen screws (Figure 13, Pos. 2) of the steel strip cover terminal strips on both
deflection stations (Figure 13, Pos. 1) and remove terminal strip.
Take care when loosening or screwing in the round-head screws. Make sure that
the tool is axial to the screw and engages completely in the hexagon socket to
prevent damage to the screw head. When tightening the screws, observe the
specified tightening torque.

Loosen screws of both carriage lids (Figure 13, Pos. 4) land remove carriage lid
(Figure 13, Pos. 3).

Carefully pull out steel strip cover (Figure 13, Pos. 5).

Carefully pull out steel strip deflections (Figure 13, Pos. 6) and steel strip sliding
rods (Figure 13, Pos. 7).

Check support profile and carriage for dirt, foreign bodies or damage. Carefully
remove heavy dirt and foreign objects.