Parker HLR070, Mounting Instructions

Page: 20 / 56

Mounting HLR Mounting Instruction
20
192-510201N1 HLR 2019-04
In this chapter you can read about:
General installation instructions ....................................................................................... 20
Installation of a single axis ............................................................................................... 21
Mounting Method of a double axis ................................................................................... 22
Correct position of loads on the carriage. ......................................................................... 26
Installation / dismantelling of the drive ............................................................................. 27
Assembly of Z-axes ......................................................................................................... 28
Assembly of accessories ................................................................................................. 34
3.1 General installation instructions
Before carrying out any installation work make sure that carriage cannot move.
Therefore, de-energize the respective drive and mechanically secure the
carriage.
Before carrying out any installation work de-energize the motor. Danger of
electrical voltage. Improper wiring may lead to severe injuries or death. A wiring
must always be made from a skilled electrician. Observe the safety instructions of
the motor used.
Always ensure that the carriage is secured against slipping, especially when the
linear actuator is mounted vertically! For this purpose, push the carriage slowly by
hand to the (later) lower position against the internal end stop, even before the
vertical position is reached.
Depending on the operating conditions (rotation speed, load, etc.) increased
surface temperature in the area of the drive may occur. When touching it during
operation slight injuries from burning may occur. Don't touch the product during
operation.
When installing the HLR linear axes in your system, make sure that the deflection
stations and the carriage are accessible for maintenance purposes! Provide
sufficient space to lubricate the carriage and the deflection stations regularly, to
replace the wear parts and, if necessary, to tighten or replace the toothed belt
and, if necessary, to open or replace the steel strip cover.
Before installation, check the supplied linear actuator for compliance with the
order confirmation, see order code on the type plate of the linear axis (complete
specification of the actuator).
We recommend to secure the screws with a liquid bolt retaining compound (e.g.
Loctite242)
3. Mounting