Parker HLR070, Mounting Instructions

Page: 33 / 56

Parker EME Assembly of Z-axes
192-510201N1 HLR 2019-04
33
3.6.3. Assembly of OSP-E20BV to single axis via mounting plates
Mounting plates for connecting the OSP-E20BV are only approved for attachment to size HLR080.
Figure 8: Assembly of mounting plates

The HLR linear axis must be mounted in the system according to these mounting
instructions (see chapter mounting of an individual axis (see page 21)).

Remove both centering sleeves on the carriage of the linear axis (please refer to
Figure 8: Pos. 7)
For the following steps the OSP-E20BV with attached motor/gear must be
present. If this is not the case, mount the motor/gear package according to the
OSP-E20BV assembly instructions.
Pre-assembly of mounting bracket

Press the cylinder pins (see Figure 8: Pos. 2) supplied into the lower mounting
plate (see Figure 8: Pos. 1). Use a one-hand lever press or a comparable,
suitable press-in device.

Then place the upper mounting plate (see Figure 8: Pos. 1) vertically on the lower
mounting plate and press it onto the pre-assembled dowel pins.

Screw together the two mounting plates with the screws supplied (see Figure
8Pos. 4) and the required tightening torque (see Table 8).
Carriage and bracket plate must be clean and free of grease.

Position the pre-assembled mounting plates on the carriage of the HLR linear
actuator, align them parallel to the carriage profile and fix them with the screws
supplied (see Figure 8: Pos. 5) and the required tightening torque (see Table 8).
Secure the Z-axis + motor/gear against tilting or lowering during the assembly
process.