25
HGF Series Service Procedure
Figure 62
Figure 61
Figure 60
Figure 59
13. Apply a small amount of clean
grease to spacer (23) and insert it
into the drive slot in the rotor (24).
See FIGURE 59. The grease will
aid in retaining the spacer during
other assembly procedures.
Install spacer
14. Place the commutator (22) on top
of the rotor (24). Be sure the
correct surface, shown in FIGURE
60, is toward the rotor. Align the
five holes and press the five
alignment pins (11) in place. See
FIGURE 61.
Install commutator
CAUTION: Make sure the five
alignment pins are pressed below
the surface of the commutator (22).
CAUTION
15. Place a few drops of oil into each
recess in the commutator (22). See
FIGURE 62.
Lubricate the
commutator
