6
“Alarm 1” default configuration as shown above
Trigger Level
: There are 3 options of Trigger Level. The options “Low” and “High” are used for turning
on alarm function. “Low” is generally used for debugging while “High” is set to enable alarm function for
on-road use. “Off” to disable trigger function.
Output Duration:
"Display" "Cursor" "Alarm Out" effect duration. Output Duration time is optional.
Alarm Out-Buzzer:
Switch ON or OFF of the Alarm Out-Buzzer. The default buzzer time lasts for 5
seconds.
Alarm Out-Output1:
Set it ON, then 12V level output would come from the alarm wire of Output 1..
Alarm 1 Rec.
：
Alarm 1 event recording switch, the recording duration is set in [System]-> [Record]->
[Event Duration]
Display:
When the alarm is triggered, the selected split mode will be displayed; the available split modes
are shown in the figure below:
Cursor
：
It is “OFF” by default. The picture below shows the open state.
