Paradyne 3163, User Manual

Page: 90 / 155

ACCULINK 3163 DSU/CSU
C-14 March 1999 3163-A2-GB20-10
Table C-6
(3 of 5)
User Interface Configuration Options
CParity: None
Next None Even Odd Prev
Communication Port Parity. Configures the parity (none, even, or odd) for the communication port.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
CStop Bits: 1
Next 1 1.5 2 Prev
Communication Port Stop Bits. Configures the number of stop bits (1, 1.5, or 2) for the communication port.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
Ignore DTR: No
Next Yes No Prev
Communication Port Ignore DTR State. Specifies whether the DSU/CSU ignores the state of the Data Terminal Ready
(DTR) input to the communication port.
Yes – DTR is ignored.
No – DTR is not ignored.
NOTE: This configuration option is not available if the communication port is configured for synchronous operation.
CmInActTm: Disab
Next Enab Disab Prev
Communication Port Inactivity Timeout. Specifies whether the communication port disconnects after a period of inactivity
specified by the CmDiscTm configuration option.
Enab – The communication port disconnects after the period of inactivity specified by the CmDiscTm configuration option.
Disab – The communication port does not disconnect due to inactivity.
CmDiscTm: 5
Next Up Down Save Prev
Communication Port Disconnect Time. Specifies the period of time (1 to 60 minutes) before the communication port
disconnects due to inactivity. (The CmInActTm configuration option must be set to Enab.) Use the left or right arrow key to
position the cursor on the digit you want to change. Use the Function keys (Up or Down) to increment or decrement the
digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.
Modem Use: ASCII
Next Mgmt ASCII Term Prev
Modem Port Use. Specifies how the modem port is used.
Mgmt – Configures the modem port as the link to a Telnet system.
ASCII – Configures the modem port as a proprietary ASCII port. This selection supports dial-out ASCII alarm messages
and dial-in/dial-out front panel access.
Term – Configures the modem port as the interface to an async terminal.