6 |
Magellan & Spectra SP • Installation Guide
User Codes
User codes are personal identification numbers for each user that allow you to enter certain programming modes, arm or disarm your system, as well as activate or
deactivate PGMs. The system supports the following:
•
1 System Master Code
•
2 Master Codes
•
29 User Codes
System Master Code (Default: 123456)
The System Master Code can arm or disarm any partition, and can create, modify or delete any user code.
Master Codes
Master Code 1 is permanently assigned to Partition 1 and can be used to create, modify or delete user codes that are assigned to Partition 1. Master Code 2 is
permanently assigned to Partition 2 (exception: when partitioning is disabled, Master Code 2 will be assigned to Partition 1) and can be used to create, modify or
delete user codes
that are assigned to the same partition.
NOTE:
Master Codes cannot modify or delete user codes assigned to both partitions. Only the System Master Code can modify or delete user codes assigned to
both partitions.
Duress Code
If you are forced to arm or disarm your system, entering the user code with the duress option enabled will arm or disarm the system and immediately transmit a
silent alert (Duress Code) to the monitoring station. The duress code must be enabled by your installer.
User Code Length
Your system can be programmed to use either 4- or 6-digit user codes, where each digit can be any value from 0 to 9. Six-digit codes are considered more difficult to
“crack” and therefore, more secure. Avoid programming simple or obvious user codes, such as your telephone number, address, or codes such as 1234.
Adding / Modifying a User
Deleting a User
How do I add / modify a user?
Visual Feedback
1
Press the
[
]
key.
2
Enter your
[
MASTER
CODE
]
.
[
]
and
[1]
flash. When a number on the
keypad is lit, the user is already programmed.
3
Select a user by entering a 2-digit user number (01 to 32).
“Arm” flashes.
4
Enter a 4- or 6-digit
[
USER
CODE
]
.
“Sleep” flashes.
5
Confirm the
[
USER
CODE
]
.
“Stay” flashes.
6
To register a remote, press and hold any remote button for 3 seconds. Release. Press and
hold any remote button for 3 seconds. If you do not wish to assign a remote, press
[
ENTER
]
.
“Off” flashes.
7
To program another user, go to step 3.
To exit, press
[
CLEAR
]
.
For partitioned systems, continue to step 8.
8
Press
[1]
and/or
[2]
to assign the user to a partition.
Press
[
ENTER
]
.
9
To program another user, go to step 3.
To exit, press
[
CLEAR
]
.
How do I delete a user?
1
Press the
[
]
key.
2
Enter your
[
MASTER
CODE
]
.
3
Select a user by entering a 2-digit user number.
4
Press and hold the
[
SLEEP
]
key until you hear the confirmation beep.
