Paradox Esprit 728 Ultra, Programming Manual

Page: 2 / 20

Esprit 728 Ultra & 738 Ultra - 2 - Programming Guide
Keypad Trouble Display
Press the [
TBL
]/[
TRBL
] key to view the trouble. Any illuminated keys represent a specific trouble as indicated in Table 3 below. Press the
[
CLEAR
] button to exit the trouble display.
Hex Programming
This is an alternate method to the Streamlined Section Programming (see page 1). Addresses 000 to 043 and 300 to 527 can be
programmed using the Hex Programming method. In this mode, you can enter any hexadecimal digit from 0 to F where keys [1] to [9]
represent digits 1 to 9 respectively; the other keys represent hexadecimal digits A to F as shown in Figure 1 below.
Figure 1: Hex Digit Data Entry and Data Display for LED Keypads
Table 3: Trouble Display
[1] - No Battery or Low Voltage [7] - Communicator Report Failure
[2] - Power Failure [8] - Timer Loss* (to clear, see [
MEM
] key in
Table 11 on page 11)
[4] - Bell Output Disconnected [9] - Tamper or Zone Wiring Failure
[5] - Exceeded Maximum Bell Current [10] - Telephone Line Monitoring Failure
[6] - Exceeded Maximum Auxiliary Current [11] - Fire Loop Trouble
Table 4: Hex Programming Method
1. Press [
ENTER
] + [
INSTALLER CODE
] (default - 728 Ultra: 282828; 738 Ultra: 383838).
2. The [
ENTER
] key will flash indicating you are in programming mode (LED keypad only).
3. Enter the desired 3-digit [
ADDRESS
].
4. The keypad will display the 2-digit data currently saved at this address as described in Figure 1 below.
5. Enter 2-digit [
DATA
] and do not press [
ENTER
], the software automatically saves the data.
6. Return to step 2 or press [
CLEAR
] to exit programming mode.
Therefore 2-digit data = 7A
= First digit = 4 + 2 + 1 = 7
= Second digit = 8 + 2 = 10
Note: Values 10 to 15 represent hex digits A to F respectively. See keypad to the left.
Each key in the first 2 rows of the keypad represents a specific value when the key is lit, as
shown above. If the key isn’t lit, the key represents 0. The sum of the values of the lit keys in
the first row correspond to the second hex digit. The sum of the values of the lit keys in the
second row correspond to the first hex digit as shown in the example below.
Sum of the second row = first hex digit
Sum of the first row = second hex digit
If the key is not lit, value = 0
Note: LCD keypads will display current data on the screen.