[
STAY
]
“
CANCEL COMMUNICATION ATTEMPTS
”
Stops calls to
Espload
.
Press
[
CLEAR
]
to exit key access programming.
The [
INFO
] key
Press
[
INFO
]
key once to enter Info mode. You can then view
three programmable messages (installer programmed). The dis-
play shows these messages with a 5 second delay between
each. You can also press
[+]
or
[-]
to view each message.
TROUBLE DISPLAY [TRBL]
10 different trouble conditions can be displayed on the keypad. When
trouble conditions occur, the display reads “trouble”, press
[
TRBL
]
.
Also, if programmed by your installer, keypad sounder will beep. If
there is a power supply failure, the display will alternate between
“
SYSTEM TROUBLE
/
POWER SUPPLY
” and the system status message.
The display will show which trouble conditions are currently tak-
ing place. Pressing on any key will return the keypad to normal
zone display.
Trouble 1
No battery/low battery
If the battery is not connected to the panel, or if it is at low capacity,
“
TROUBLE
01
BATTERY
” appears in the display. The battery connected
to the panel should be replaced, because it can no longer provide
adequate back-up current in the event of a power failure. The trou-
ble
will also
be displayed if battery voltage drops to 10.5 volts while
the control panel is running on battery power (with no AC).
Trouble 2
Power failure
If AC power is not being supplied to the control panel
and/or
the
UM639
21
ture, continue pressing
[
ENTER
]
to scroll through the list.
Note: Chime zone is always audible.
Key Access Programming
Several
control panel
features can be programmed quickly on
the keypad, without entering any programming addresses or sec-
tion numbers. Select “one-key access” programming by pressing
[
ENTER
]
, followed by the master or user code 1. Then press the
single key (listed below) corresponding to the feature you wish to
activate. Verify first with your installer that all of the features list-
ed have been programmed and activated on your control panel.
[9]
“
AUTO ARMING TIME
”
PROGRAMMING
Display shows “
AUTO ARMING TIME
” “
ENTER IN
24
HRS
”. Enter two
digits (
00
to
23
) for hours, and two digits (
00
to
59
) for minutes.
[
MEM
]
"
PANEL TIME
" (and “
CLEAR TROUBLE
8
”)
Display shows “
CLOCK MODE
” “
ENTER IN
24
HRS
”. Enter two dig-
its (
00
to
23
) for hours, and two digits (
00
to
59
) for minutes.
[
BYP
]
“
TEST REPORT
”
Press this key to send a test report from your alarm sys-
tem to the central monitoring station.
[
TRBL
]
“
CALL ESPLOAD VIA TELEPHONE
”
If programmed by your installer, this initiates communica-
tion to the central monitoring station computer using
Espload
software.
[
AWAY
]
“
ANSWER ESPLOAD
”
This feature initiates “modem” communication between
your panel and a computer running
Espload
software.
(The ADP-1 adapter can also be used.)
UM639
20
