ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
L
Do not use the wheel gun with the screws of
the clutch cover
(view figure Fig.1-E
) or the
motor cover (
view figure Fig.1-P
) loose or not
tight enough (
see table Tab. A “Tightening
Torques”
). If not tighten them with a torque
wrench following the tightening sequence
shown (
view figures Fig.2-E and Fig.2-F
).
L
Pay attention to the exhaust coming out
by the wheel gun during operation (
view
figure Fig.2-B
). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L
Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L
Do not operate the wheel gun without the
prescribed safety devices.
L
The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L
Verify that the WARNING label (
view figure
Fig.1-W
) is present and legible, otherwise
replace it by applying new one in the original
position.
GENERAL INSTRUCTIONS
L
Always use a wheel gun with the tightening
torque corresponding to the one required by
the application.
L
If you avoid operating at a higher pressure than
the one required you will save energy, make
less noise, and have less wear on the appliance.
L
In order not to compromise the functionality
of the rotation reverse shaft, do not unscrew
or loosen never the grub screw of the motor
cover (
view figure Fig.2-C
).
L
The modes for the correct grip intended
for use of the wheel gun is as follows
(view
figure Fig.2-G
):
⚪
right hand grip on the gun body;
⚪
left hand grip on the surface of the hammer
case.
L
The standard adjustment of the force
necessary for the translation of the rotation
reverse shaft, and thus the reverse is
already performed by Dino Paoli s.r.l.. A
personalized set of this force is possible,
however, for specific needs of the operator,
acting uniformly on the nr.2 (two) rotation
reverser grub screws (
view figure Fig.2-D
).
Tightening the grub screws you will have
an increase in the force required, loosening
them you will have its decrease. Ensure
that the individual regulation does not
create problems of accidental reversal
of the direction of rotation. Perform this
adjustment always disconnected the wheel
gun from the air supply.
OPERATING INSTRUCTIONS
L
Before the use, always perform a dynamic
adjustment of the supply air pressure (
view
figure Fig.6
). Adjust the supply air pressure
on the low pressure gauge turning the
adjusting screw of the air pressure regulator
while keeping the trigger pressed.
L
Do not exceed the maximum supply air pressure
of 175 psi (12 bars) with wheel gun running.
REGULATION OF
THE AIR PRESSURE
L
Slide the rotation reverse shaft (
see
figure Fig.1-I
) and push the trigger (
view
figure Fig.1-C
). See the figure
Fig.5
to
identify the rotation direction of the
square drive.
L
Avoid accidental starting, being careful not
to unwittingly act on the trigger (
view figure
Fig1-C
).
HANDLING
Summary of Contents for RED DEVIL BLACK BIRD
