CABINET SENSOR HARDWARE INSTALLATION
MANUAL
19
Solid Door and Open Frame Cabinets
Use brackets with adhesive backing or Unistrut brackets to install ThermaNode EZ kits
on solid doors and open frame cabinets.
Installing the ThermaNode EZ using Brackets with Adhesive Strips
1. Clean area where
ThermaNode EZ will go and
allow to dry thoroughly.
2. Remove adhesive strip covers
from the bracket and install the
node.
•
Solid door
: position “S”
vents close to the door
centerline.
•
Open frame
: point external
sensor connector points
toward the center of the
cabinet
3. Press firmly for 30 seconds to
ensure a secure bond.
4. Install the Bend N’ Stay for
open frame cabinet
configurations
only:
•
Insert the Bend N’ Stay
external sensor into the
external sensor connector.
•
Position the Bend N’ Stay
external sensor to the
desire location. Do not bend
or exert pressure in the first
3-4 inches from the sensor
connector.
•
See the following page to
remove a Bend N’ Stay.
5. Repeat the previous steps as
applicable to install the next
node according to the
MapSense layout.