CABINET SENSOR HARDWARE INSTALLATION
MANUAL
18
Mesh Door Cabinets
Use pin badges or cable ties for installations on mesh door cabinets.
Installing ThermaNode EZs with Pin Badges
1. Remove the logo faceplate from the pin badge
by turning the spring screw counter-clockwise.
2. From the inside of the door, position the node
on the door and press the spring screw through
the mesh. Position the “S” vents close to the
door centerline.
3. On the outside of the door, attach the
logo faceplate to the spring screw
and tighten screw. Make sure the
logo is face up.
4. Repeat the previous steps to install
the next node according to the
MapSense layout.
Commissioning the ThermaNode EZ
Installation
Installing ThermaNode EZs Using Cable ties
1. Insert a cable tie through the mounting hole at each corner of the node.
2. Insert cable tie ends
through the mounting
holes/surface provided
positioning “S” vents close
to the door centerline.
3. Secure on the inside of the
cabinet.
4. Repeat the previous steps
to mount the next node.
Validating and Commissioning the ThermaNode EZ Installation
