© Panduit Corp. 2018
OPERATION MANUAL
PES400
ENGLISH
PES400: PA28981A01_01
Page: 5 of 46
4-2018
1.4.3 Windows 7, 8 and 10
a.
Connect the USB to serial cable to serial cable from embosser and USB port
on computer.
b.
Operating system will automatically download the driver.
1.5 Install External Hopper
1. Use the 2 screws provided to mount external hopper. Place the screw heads to the
outside, nuts and washers to the inside of the embosser.
2. Slide hopper back and forth on screws to line up divider in 0.75” (19mm) slot, see
[
Figure 24
], with side eject guide plate @ 0.75” (19mm) see [
Figure 23
].
3. Tighten screws to lock hopper position.
1.6 Easy-Mark Plus™ Software Installation
***Version 1.2 or higher is required to operate the PES400 Embossing System***
SYSTEM REQUIREMENTS:
-
Windows XP, Vista, 7, 8, 9, or 10
-
32 or 64 bit operating systems
-
Microsoft .NET Framework 4.0 or higher
-
300MB of hard drive space and 2 GB of Memory
-
USB port
-
Mouse or compatible pointing device
-
Keyboard
Perform the following steps to install the Easy-Mark Plus™ labeling software:
1. Insert the provided USB Flash Drive into an available USB port on the destination PC.
NOTE: DO NOT remove the label from USB drive.