© Panduit Corp. 2018
OPERATION MANUAL
PES400
ENGLISH
PES400: PA28981A01_01
Page: 31 of 46
4-2018
4.2.12 Turn on PES400
The machine can be switched on with the main switch (located in back of
machine).
NOTE: Prior to switching “on”, make sure cover is closed.
The display will appear with the message as shown below:
E001 POWER-ON VER. MC-X.XX
PRESS CLEAR or ESC TO CONTINUE
Press the
CLEAR
key on right side of the front panel beside the display. This
activates a general reset which, when completed, will leave another message on
the display to indicate the Ready state of the machine.
PANDUIT EMBOSSING SYSTEM: PES400
READY
If the machine does not start, check that the power supply is correctly set and
that the main fuse has not been shorted.
If error message appears, please refer to the “Error Code” section on [
Page 38
].
NOTE: If the display is turned on but nothing appears on the screen,
switch the machine off and call for Technical Assistance.
(see Regional Contact Information on Page 46)
The machine is now ready to run.
4.2.13 Open and use Panduit Easy-Mark Plus™ software
a.
Start Easy-Mark Plus™ with a double-click on the Easy-
Mark Plus™ icon, which should be present on the
Desktop.
b.
Insert the serial number, if it is requested, and click “Activate” to start the
first work session with Easy-Mark Plus™. The serial number is located on
the Flash Drive packaging.
c.
After the application completes its first launch (this could take a couple
minutes), the Landing Page is presented, which helps with selection of the
document formats.
