© Panduit Corp. 2018
OPERATION MANUAL
ENGLISH
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
PA27647A01_05
Page: 10 of 64
12-2018
Contact Panduit Electrical Products Division at the following locations:
Panduit Electrical Products Division (USA)
16530 W. 163
rd
Street
Lockport, IL 60441
1-800-777-3300
Panduit EMEA Service Center (EUR)
EMEA Tool Service Center
Bedrijvenpark Twente 360
7602 KL Almelo
tel + 31 546 580 451
4: SAFETY PRACTICES ADDENDUM
4A: General Safety Practices
1.
Panduit Corp. recommends the tool be used with all installed safety features. Customer
assumes all liability for injury that could result from improper use of this tool and
responsibility for all necessary training to ensure safe operation of this tool.
2.
To prevent unintentional injury, DO NOT place the PDM4.0 where a ladder is required for
access.
•
For installation and use by trained personnel only
•
If any damage to the product is apparent or suspected, do not use the product. refer product
to qualified service personnel
•
FCC Warning: changes or modifications to the product could void the user’s authority to operate
the product
4B: Electrical Safety Practices
KEEP AWAY FROM LIVE CIRCUITS
1.
Operating personnel must use caution when opening cover
2.
Replacement of components and internal adjustments must be made by qualified maintenance
personnel
3.
Disconnect power cable when replacing components
4.
Dangerous voltages may exist even with the power cable removed
5.
To avoid injuries, always disconnect power and discharge circuits by grounding before touching
circuitry
6.
Input connection to the product must remain accessible as a disconnect device
7.
DO NOT work on the product; connect or disconnect cables during periods of lightning
8.
Provide wiring per national and local electrical codes
4C: Operational Safety Practices
1.
DO NOT insert fingers in between the jaws of the tool or the rotary receiver area of the
dispenser.
2.
DO NOT attempt to operate the tool with cover open and the safety mechanism disabled.
3.
DO NOT attempt to operate the tool with the cover open; the system will not cycle.
4.
DO NOT operate the tool with the rear jaw held open. Cable ties may be ejected from the tool at
high velocities.
5.
DO NOT operate the tool near anyone's face.
6.
DO NOT operate the tool without a wire bundle in the jaws.
7.
DO NOT operate the tool with any object blocking the path of the cable tie around the jaws.
8.
ONLY OPERATE THE PAT SYSTEM IN A CLEAN, DRY, INDOOR ENVIRIONMENT
Summary of Contents for PAT1.5M4.0
Page 2: ......
