© Panduit Corp. 2018
OPERATION MANUAL
ENGLISH
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
PA27647A01_05
Page: 40 of 64
12-2018
ERROR > HELP
PRESS AIR BURST, REMOVE TIE
AIR BURST
LOAD
MAINTENANCE
PREVIOUS
BACK
63
Help Screen Step 3
POSSIBLE CAUSE:
This will occur if the tool (optical) sensor in the tool becomes obstructed due to a cable tie
or excess debris (dirt, grime, etc.) on the lens. The cable tie will remain in the tool or the end of the PHM Feeder
Hose that is attached to the tool. When this occurs, the tool cannot be actuated until the cable tie or ties are
cleared from the tool or feeder hose.
CORRECTIVE ACTION:
Press the
“Silence” icon
to turn the alarm signal "off". Disconnect feeder hose from
tool. Look for cable tie in tool jaws or tool end of hose and remove cable tie, if present. Reconnect feeder hose,
and resume operation. If cable tie is not found, reconnect feeder hose. Straighten the feeder hose to eliminate
any bends or twists and point the tool away from yourself and others. Press the
"Air burst"
icon to provide a
burst of air to dislodge and advance the cable tie to the jaw area of the tool. The
"Air Burst"
icon can be pressed
again if the cable tie does not advance to the jaw area. When the cable tie is advanced to the tool jaw area, the
"Tie in tool" message will appear and the alarm signal will sound. Press the
“Silence” icon
to turn the alarm
signal "off". Remove the cable tie from the jaw area and then press the
"Back"
icon. Press the
"Load"
icon to
load cable tie into the dispenser and continue operation. If the cable tie does not advance to the tool jaw area
after depressing the
"Air Burst"
icon several times, replace the feeder hose with another and notify your
maintenance department.
PREVENTION:
If this same error is repeated, the tool sensor lens may require cleaning. Contact your
maintenance department to have the tool sensor lens cleaned.
ERROR 11 - Tie stuck, exit sensor obstructed
ERROR 11 > TIE STUCK
EXIT SENSOR OBSTRUCTED
AIR BURST
LOAD
MAINTENANCE
SILENCE
HELP
BACK
65
Error Screen
Summary of Contents for PAT1.5M4.0
Page 2: ......
