© Panduit Corp. 2018
OPERATION MANUAL
ENGLISH
PAT1M4.0, PAT1M4.0-BT
PAT1.5M4.0, PAT1.5M4.0-BT,
PDM4.0, PHM
PA27647A01_05
Page: 52 of 64
12-2018
INTERVAL
MAINTENANCE PROCEDURE (See Figure 8 below)
LUBRICANT
Every
100,000
cycles
Clean tool housings and gears of debris (not shown).
(Maintenance department must perform this procedure.)
N/A
1. Lubricate detent cam follower.
(Maintenance department must perform this procedure.)
General Purpose
Light Machine Oil
2. Clean and lubricate all pivots and shafts.
(Maintenance department must perform this procedure.)
3. Oil shaft (1 drop) on each side of Gripper Drive Gear.
(Maintenance department must perform this procedure.)
4. Clean and re-grease the Cam on the Front Jaw Gear.
(Maintenance department must perform this procedure.)
Schaeffer's Moly Ultra 800 EP
Every
200,000
cycles
Replace PHM Hose (not shown).
N/A
4. Replace the left hand housing in position and fasten the left hand housing to the tool using the 5 socket
head cap screws removed in Step 2 (see Fig. 20). Use a 2.5 mm hex wrench to torque the cap screws to
60 oz - in (0,42 Nm).
5. Replace tip collector and attach PHM Feeder Hose as required to resume operation.
The following maintenance procedures may be required every 500,000 cycles or more. Contact your maintenance
department as required to perform the following procedures at the prescribed intervals.
INTERVAL
UNIT
MAINTENANCE PROCEDURE
Every 500 000 cycles
(=100 cable tie reels)
PAT1M4.0
PAT1.5M4.0
Clean tool sensor lens.
(Maintenance department must perform this procedure.)
PDM4.0
Clean dispenser, tie and exit sensor, lens.
(Refer to
Cleaning the Dispenser Exit Sensor Lens
section
below.)
Every 750,000 cycles
(=150 cable tie reels)
PAT1M4.0
PAT1.5M4.0
Replace tool transfer tube, if worn.
(Maintenance department must perform this procedure.)
Every 1,000,000
cycles
(=200 cable tie reels)
PDM4.0
Clean and re-grease piston and O-rings in connection block.
(Maintenance department must perform this procedure.)
Fig. 21
Summary of Contents for PAT1.5M4.0
Page 2: ......
