INSTRUCTIONS CM408F
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 23 of 24
Cabinet Sealing
Single Hinge Door Handle Reversal
Door Catch Blanking Panels must be adjusted if Single Hinge Door Handle direction is to be reversed from default orientation
(see page 13)
.
Remove #6 Phillips counter-sink screw to adjust Door Catch Blanking Panels. Reposition blanking panels
(maneuver blanking panels around
rubber door bumper)
as described below. Secure blanking panels in new position with #6 Phillips counter-sink screw.
Right Door Catch Blanking Panel
is to be adjusted upwards to blank both door catch openings. New position is indicated by dashed lines.
Left Door Catch Blanking Panel
is to be adjusted upwards to blank upper door catch opening only. New position is indicated by dashed lines.
Right Door Catch
Blanking Panel
(Adjust upwards so that
both door catch openings
are blanked)
LEFT DOOR CATCH
BLANKING PANEL
RIGHT DOOR CATCH
BLANKING PANEL
Rubber Door Bumper
(Maneuver blanking panel
around bumper when
repositioning)
#6 Phillips Screw
Default Blanked Area
Right Door Catch
Blanking Panel
(Adjust upwards so that
both door catch openings
are blanked)
Rubber Door Bumper
(Maneuver blanking panel
around bumper when
repositioning)
#6 Phillips Screw
Default Blanked Area
