OmniStream
5
Getting Started
A network switch will be needed to power and pass IP traffic. A list of certified switches is provided below with
download links for prebuilt configurations. Atlona recommends using a switch from the certified list to ensure
compatibility.
For configuration of the OmniStream devices with this guide, Velocity with integrated AMS (Atlona Management
System) will be needed. AMS has two options: AT-VGW-HW-3/AT-VGW-HW-10/AT-VGW-HW-20 hardware (with
integrated AMS) or AT-AMS-SW free software. AT-VGW-HW-3/10/20 can be purchased at:
or AT-AMS-SW free software can be downloaded from
https://atlona.com/product/at-ams-sw/.
AMS will be needed before progressing further into this setup and configuration guide.
•
When using multiple of the same OmniStream devices, or for reference, labeling can be used. It’s best to place
the label on the front of the device for visibility. When labeling, notate the last 4 numbers of the MAC address,
found on the bottom of the unit on the label, for easier IP discovery and notation later.
•
Use a component surge suppressor with line conditioning for best results.
Certified Switcher
Download
Configuration
Cisco SG300-10MPP
The default configuration can be found within the
OmniStream Certified Network Switches document
that can be found at
OmniStream_Certified_Switches.pdf.
Cisco SG300-28MP
Cisco SG300-52MP
Cisco SG350-10MP
Cisco SG350-28MP
Cisco SG350-52MP
Cisco SG550X-24MP
Cisco SG550X-48MP
Pakedge S3L-24P
Luminex GigaCore 26i
Ruckus ICX 7150-48ZP
Ubiquiti ES-48-500W /ES-48-750W
Selecting a Network Switch
Velocity with Integrated AMS - Purchase or Download
Recommendations
IMPORTANT:
Atlona’s warranty does not cover damage due to electrical disturbances. A component
surge suppressor with line conditioning is highly suggested, especially in areas with electrical storms.
