USER MANUAL
The system will automatically enter the sublevel 11.1 (Selecting buttons)
after entering the level 11. The system can determine buttons via analog «Code
immobilizer» input or via digital protocol of a car. It is necessary to configure an
analog input (INP) as «Code immobilizer» in the settings of the base unit inputs when
implementing the «Code immobilizer» via an analog input. It may be necessary to
switch on the ignition after entering the level 11 of programming (if the car bus
is active only when the ignition is switched on) when implementing the «Code
immobilizer» via digital car bus protocol.
After selecting active buttons enter the sublevel 11.2 (Entering PIN-code) by one
pressing of
VALET
button. Program PIN-code using selected buttons at this sublevel;
press
VALET
button once and enter PIN-code again. To confirm PIN-code re-entering
and save all the settings, press
VALET
button once again.
Sublevel 11.1 – Selecting buttons:
This sublevel is used to select active buttons via digital protocol of a car or via «Code
Immobilizer» analog input. To determine the activity of the analog «Code Immobilizer»
input, apply potential to the corresponding input (INP) of the base unit,
LED
indicator
will be flashing orange.
If you determine buttons via digital protocol select one or more buttons (up to four)
for entering the secret code of the immobilizer. To do this press the selected button,
LED
indicator will confirm input with orange flashes. If there are no orange flashes
when any button is pressed, then this button is not recognized by the system, select a
different button. Repeat the procedure to select the second, third, fourth button and
enter the next sublevel. To enter the next sublevel press
VALET
button once.
Sublevel 11.2 – Entering PIN-code:
Program immobilizer deactivation PIN-code using selected button or buttons. Enter
the first digit by pressing the previously selected button (pauses between presses
should not exceed 1 second). The base unit will confirm entering with red flash
of
LED
indicator. Enter the second (third, fourth) digit by pressing the previously
selected button. The base unit will confirm entering of each digit with red flash of
P R O G R A M M I N G T H E S Y S T E M