PANDORA LIGHT PRO SERVICE-SECURITY SYSTEM
•
Wire «8» (Black) («Ground»)
— It should be connected to the car body in a
grounding spot. This wire should be connected FIRST during installation.
•
Wire «9» (Blue) (INP4)
— Factory setting is «Neutral/Handbrake». This wire
connects to appropriate neutral/handbrake wire of the car. This input is
multipurpose, it can operate in accordance with selected logic.
•
Wire «10» (Brown-white) (INP3)
— Factory setting is «Front hood trigger». This
wire connects to appropriate wire that becomes grounded when the front hood
opens. This input is multipurpose, it can operate in accordance with selected logic.
•
Wire «11» (Orange-black) («CAN-Low»)
— It connects to appropriate CAN-Low
wire of the car.
•
Wire «12» (Yellow-black) (СН2)
— Factory setting is «Close central lock». A
negative impulse of 0,8 seconds is formed on the wire to close central lock. A
negative output of additional channel with maximum load capacity 200mA. This
output is multipurpose, it can operate in accordance with selected logic. CH2
output stops to operate as an output when a car model supported CAN2-bus is
selected.
•
Wire «13» (Blue-black) (CH1)
— Factory setting is «Free output». A negative
output of additional channel with maximum load capacity 200mA. This output is
multipurpose, it can operate in accordance with selected logic.
•
Wire «14» (Yellow) (INP6)
— Factory setting is «Ignition». This wire connects to
ignition lock or to appropriate wire where 12V voltage appears when ignition is
enabled and doesn’t disappear until the moment ignition is disabled. This input is
multipurpose, it can operate in accordance with selected logic.
•
Wire «15» (Purple) («Siren»)
— It connects to siren control wire (+) (maximum
load current is 2A). This output is multipurpose, it can operate in accordance with
selected logic.
•
Wire «16» (Red) («Power supply» +12V)
— It should be connected to reliable
conductor with constant voltage of 12V.
W I R I N G D E S C R I P T I O N • W I R I N G D I A G R A M
