USER MANUAL
WIRING DESCRIPTION
Х4 Main Socket
•
Wire «1» (White) (Tachometer input)
— analog input of the tachometer signal,
it connects to the tachometer wire or to the signal wire of a nozzle which provides
stable pulses of any polarity corresponding to the RPM.
•
Wire «2» (Red-black) (CH5)
— Factory setting is «Opening trunk». A negative
output of additional channel with maximum load current 200mA. This output is
multipurpose, it can operate in accordance with selected logic.
•
Wire «3» (Orange-white) («CAN-High»)
— It connects to appropriate CAN-High
wire of the car.
Wire «4» (Yellow-white) (СН4)
— Factory setting is «Opening central lock». A
negative impulse of 0,8 seconds is formed on the wire to open central lock. A
negative output of additional channel with maximum load current 200mA. This
output is multipurpose, it can operate in accordance with selected logic. CH4
output stops to operate as an output when a car model supported CAN2-bus is
selected.
•
Wire «5» (Gray) (INP2)
— Factory setting is «Doors trigger». This wire connects to a
wire that becomes grounded when a door opens. This input is multipurpose, it can
operate in accordance with selected logic.
•
Wire «6» (Green) (СН3)
— Factory setting is «Turn indicators». This wire connects
to the hazard flashers button. A negative output of additional channel with
maximum load current 200mA. This output is multipurpose; it can operate in
accordance with selected logic.
•
Wire «7» (White-blue) (INP5)
— Factory setting is «Brake pedal». This wire
connects to the brake pedal button where 12V voltage appears when the pedal is
pressed (stop lights wire). Brake pedal signal is one of the system’s security zones.
This input is multipurpose, it can operate in accordance with selected logic. This
input can be assign as «Fuel level control». Calibrating of fuel level can be perform
in Programming mode using «
VALET»
button.
W I R I N G D E S C R I P T I O N • W I R I N G D I A G R A M
