AT-OME-ST31A
27
Configuration and Management Interfaces
CEC Command
Click the ON button to send the power-on command to the display device. Click the
OFF
button to toggle the power
state to off.
Consumer Electronics Control (
CEC): Atlona has confirmed proper CEC functionality with several current models of
Samsung, Panasonic, and Sony displays. However, it is not guaranteed that CEC will work with all displays. Many
manufacturers do not support the CEC “off” command, and older displays use proprietary commands. Atlona only
supports displays that use the CEC command structure defined in HDMI 1.2a. It is recommended that dealers re
-
quest an evaluation product from Atlona, before designing a system using the CEC protocol. If this is not possible,
then other control methods will need to be considered, in order to control displays using Atlona products.
Display Auto Power On
Set this toggle to ENABLED to allow the AT-OME-ST31A to send the power-on command to the display when an A/V
signal is detected. When the AV signal is no longer present, the AT-OME-ST31A will send the power-off command to
the display. If this feature is not desired, then set to DISABLED. This feature is disabled by default.
Auto power off timer
Sends the command to power-off the display when an A/V signal is no longer present. Click the toggle to enable or
disable this feature.
Lamp cool down timer
Sets the cool-down interval, in seconds, before the projector can be powered-off. During this time interval, the
projector will not accept any “power on” or “power off” commands until the last “power off” command has been
processed and the projector lamp has completed the cool-down cycle. Range: 0 to 300.
Display Warm-Up Timer
Click this drop-down list to select the display warm-up time interval. Range: 10 to 300. The default value is 10
seconds.
Display Page