AT-OME-ST31A
26
Configuration and Management Interfaces
HDCP
Each input provides control of how HDCP content is handled. Some source devices will send HDCP content if an
HDCP-compliant display (sink) is detected. However, there may be applications where sending HDCP content is not
desired. Setting the port to the
OFF
position, will instruct the source to send non-HDCP content to the display.
Note that not all sources have this capability.
Scaler Pass-Through
Click this toggle switch to enable or disable the scaler pass-through feature. When set to the
ON
position, no scaler
processing is used and the output resolution / timing will be the same as the input source. When disabled (
OFF
),
4K content will be down-scaled to 1080p. By default, this feature is set to the
OFF
position, which provides scaling
capability.
Audio
Manages audio settings for inputs and outputs.
• HDBaseT Output
Set this toggle to the
OFF
position to mute the audio on the
HDBaseT OUTPUT
port. The default setting is
ON
.
• HDMI Output
Set this toggle to the
OFF
position to mute the audio on the
HDMI OUTPUT
port. The default setting is
ON
.
• Analog Output
Set this toggle to the
OFF
position to mute the audio on the
AUDIO OUT
port. To de-embed audio from the
source, set this toggle to the
ON
position. The default setting is
ON
.
NOTE:
Setting this feature to
OFF
, for any source, does
not
provide decryption of HDCP content to
non-HDCP compliant sink devices. Sources such as Mac
®
computers and the Sony PlayStation
®
will
always
transmit HDCP content.
• ON
When set to
ON
, the source will transmit HDCP content to the AT-OME-ST31A.
• OFF
When set to
OFF
, non-HDCP content will be transmitted (if possible) to the AT-OME-ST31A.
IMPORTANT:
The AT-OME-ST31A will only de-embed two-channel LPCM audio. Down-mixing
mulitchannel audio to two-channel audio is not supported.